1967 Ford Mustang

Embark on a captivating journey through the golden era of American muscle cars with Texoma Classics as we meticulously restore a 1967 Ford Mustang in Sherman, Texas. This vintage Ford Mustang isn’t just a car; it’s an icon of power, style, and timeless appeal, and we’re dedicated to bringing it back to its former glory. Join us on a thrilling visual voyage through the restoration process, where the spirit of classic Mustangs meets modern craftsmanship and innovation.

Restoration Progress

Our team at Texoma Classics is excited to work on this Mustang! Our first step is to verify the engine and transmission and assess if the 4-link can be utilized. Once we’ve gathered all the necessary information, we will move forward with completing the restoration of this classic car. Stay tuned for updates on our progress!

We are currently in the process of preparing to box in the frame for the installation of the new cross member. This will help strengthen the frame and ensure the safe and proper function of the vehicle. We take great care in every step of the restoration process to ensure the highest quality workmanship for our clients.

We have completed the boxing in of the frame as part of the restoration process. This step helps to strengthen the frame and ensure the vehicle’s safety and performance. Our team takes great care in every aspect of the restoration process to provide the highest level of quality and attention to detail.

The suspension and rear end of the vehicle have been fitted with new mounts.

The installation of new rotors and brakes has been completed.

We have installed the cross brace and splash shield.

The installation of the new EFI system and fuel tank has been done.

Beginning to install the new wiring harness in the dash.

Dynamat has been installed to reduce road noise in the vehicle.

The fuel pressure regulator and fuel lines have been installed.

The taillights have been installed.

The fuel door has been installed.

We have installed 4 link rear suspension, rear axle, disc brakes and passenger side parking brake.

Uncreating the new Coyote engine that will be installed.

Beginning to run the wiring throughout the engine bay.

We had to fabricate the transmission tunnel a little bit.

The sway bar has been installed.

The fabricated transmission tunnel has been painted black.

We had to relocate the master cylinder to the right about 2 inches.

Installed engine transmission computer in front passenger wheel well.

We have begun installing the passenger side header.

We will be relocating the AC lines from the firewall to the wheel well.

Making progress on running the wiring harness throughout the dash.

The fender has been reinstalled.

Engine, headers and power steering reservoir have been installed.

The headlights have been installed.

The radiator has been installed.

Heater hose installed throuhout engine.

The new seat cushions have been custom built out of foam.

The beginning builds of the custom console.

Test fitting the driver’s seat and custom console in the interior of the vehicle.

The start of the fabrication of the storage lid.

We have hidden the AC lines in the wheel well to keep a clean look in the engine bay.

We have begun building the cool air intake system.

The power steering lines have been installed.

The starter is being wired into the wiring harness.

Relocated the battery and the ground wire to the trunk.

Install passenger side side mirror

New seat belts installed and cleaned out interior

Sequential tail lights

New steering column installed